In this video you see me building a giant onewheel with hoverboard parts.
I used the 2 motors, motherboard, one gyro sensor, and battery from the hoverboard. It can be charged through the hoverboard charging port.
To make the motherboard accept signal from left gyro sensor you should loop the blue and green wire to the input from the right gyro sensor on the motherboard.
To make the motors turn in opposite direction you should rewire the hall sensor of one motor: blue to yellow and yellow to blue. Motor main power should be wired: blue to green, green to blue, yellow to yellow.
With these modifications 1 gyro sensor should control the 2 motors together, which are spinning in opposite direction now. I built a test setup first to make sure all this would work.
The result is a working onewheel, however riding it is difficult. But that’s maybe just me, I can’t ride a regular hoverboard either :). After some practice I succeeded in riding in a straight line, corners I don’t master yet.
I hope this video helps people who also want to attempt such project. I am sure if you use a smaller wheel it will be much easier to ride.
Chapters
0:00 – intro
0:26 – hoverboard disassembly
1:53 – test setup + testing
3:10 – mounting motors to the wheel
7:07 – building the frame
11:23 – making fibreglass battery tray and electronics tray
13:56 – welding it out
14:21 – painting
15:12 – final assembly
18:19 – presentation of the finished project
19:22 – testdrive
Thanks for watching. If you like this kind of projects consider subscribing.
Feel free to check out some of the other builds on my channel.
source
0 Comments